Tools
- Jig Saw
- PSR 18 -2 LI Cordless Drill
- PSR 10.8 Cordless Screw Driver
- Iron
- PMF multi tool with sanding attachment
- Dremel 4000 rotary tool
- Router attachment
- Groove router bit cutters
Material list
- 16mm veneered board (same colour as the book shelf in your dining room)
- 1000 x 1000 mm. 2 pieces edged on left side and back side with 3mm black plastic edging. (other two edges leave clean)
- 638 x 638 mm. 1 piece (no edging)
- 620 x 200mm. 4 pieces. Each one edged on 1 long side with 3mm black plastic edging.
- 970 x 620mm. 1 piece. Edged on 1 short side with 3mm black plastic edging.
- 954 x 620mm. 1 piece. Edged on 1 short side with 3mm black plastic edging.
- brown plastic caps to close screw holes. (Closest colour to wood) If you can’t get then get closest colour wood filler
- 6mm glass. 300 x 190mm. 6 pieces all edges dressed (to take off sharp edges)
- 24 glass shelf brackets (same type we normally use that push into the hole on the side of the wood)
- 6 x wheels or legs. (Nice steel legs would look better than wheels but speak to Mathew)
- 1 x round cap for the top where the electric cables go through.
- Brown plastic brackets with small cover plates to cover screws (four hole)
- Black pre-glued edging x 10 mtrs
- 6-9mm super wood. 300 x 300 mm 1 piece.
- Dark brown spray paint (you might still have some from the cheese board)
- Clear varnish
- 4 x 40mm chipboard screws