On Air 08:00 - Design for you
Next 08:30 - Weekend Reno

Pergola

What you will need:

Tools Material list
GST 18 Jig saw 20mm pine PAR
18 volt Cordless Drill driver  Pine 38 x 114 x 2400 – 5 pieces
PSR 10.8 Pine 38 x 114 x 3900 – 1 piece
spray gun Uprights – 75 x 75 x 2800 – 3 pieces
Pex 220 sander Shade net – 4.1mtr x 2.4mtr – 1 piece
PBH rotary hammer (drill bit size same as wall anchor) pine 38 x 38mm x 4.0mtr – 2 pieces
PCL 20 plus pole pine 38 x 38mm x 2mtrmtr – 1 pieces
Small angle grinder plus skinny disc Corner brackets (75 – 100mm) – 20 pieces
  Ply wood 18mm – 700 x 1400 – 2 pieces
  Pine 20mm – 114 x 700 mm – 4 pieces
  wall anchors – 12 pieces
  4 x 40mm screws
  4 x 60mm screws
  Tec screws plus roof washers
  wood glue ( waterproof)
  Varnish 

Steps for building a Pergola

  • First we cut out the shape on the roof slats.
  • Then we cut hoople iron to size and drill holes
  • Fit upright poles
  • Attach cross slat on top of upright poles
  • Fit roof slats above the cross slat and back board
  • Varnish
  • While varnish is drying make a new top for Mathews table and varnish this.
  • Fit shade net to pergol

Download and Print the plan

Plan for building a Pergola

This week’s Bosch Tool Tip