This is what you’ll need
Material List: | Tools: |
Meranti 20 mm | Jig saw |
600mm x 400mm – 2 pieces | Cordless drill drivers |
600 mm x 368mm – 1 piece | PDB 40 Drill press |
400mm x 400mm – 2 pieces | Router |
40 mm x 500 mm – 4 pieces | 3mm straight cutter – router bit |
Clear Perspex 3mm – 370 x 585 mm | Angle Grinder with multi construction discs (skinny ones) |
Small fan (computer type – 220volt) x 1 | |
Aluminium rods 8-10mm 500mm x 4 | |
plastic end caps x 8 to fit rods | |
wood glue | |
4 x 40mm screws | |
non toxic oil |
Biltong Dryer
Steps
- Mark out where sides, back and bottom join
- Router out groove for Perspex on the side and bottom
- Drill holes for aluminium rods in sides
- Join sides, back and bottom
- Drill hole in lid for fan
- Join the top and skirting for the lid
- Sand and seal
- Slide Perspex into front
- Cut rods to size and install