Shopping List
- Table top of 30mm thick cut to 800mm x 2100mm Pine 20mm thick cut to sizes of:
- – 4 pieces of 600mm x 700mm
- – 4 pieces of 100mm x 700mm
- – 2 pieces of 180mm x 640mm
- – 1 piece of 300mm x 2100mm
- 6 cleats of 20mm x 20mm x 600mm
- 4 x 40mm chipboard screws
- Water resistant wood glue
- 5l Gripseal (Indonesian/Dark mahogany)
Tool List
- PKS circular saw
- PSR 14.4 cordless drill
- PSR 10.8 cordless screw driver
- POF 1200 AE router
- PEX 220 random orbital sander
- PFS65 spray gun
STEPS:
Making the legs.
- Draw out on the front and back panels where the sides must go.
- Drill pilot holes
- Glue and screw sides onto the front and back panel.
- Draw out where leg fits onto base, and drill pilot holes.
- Attach legs to base
- Fill holes with filler and when dry sand smooth.
Making the top
- Have table cut to size
- Round off edges with a router
- Turn table top upside down and attach blocks where legs must fit
- Attach cleats where cross beam will go.
- Attach legs with glue and screws to the block.
- Put cleats in the middle of the inside side panels of the legs.
- Attach middle cross beam to cleats with glue and screws.
- Sand the whole table and Varnish.